smart-sensor-status-timer

This timer works in conjunction with smart-sensor. The timer function is handled exclusively by the RF domain manager (RFDM). When the timer expires, the RFDM checks radio sensor status. If all sensors are "Off", recalibration for smart-sensor is triggered.

Note

Smart-sensor auto-trigger must be enabled (default) for the timer feature to work.

The following events result in a start/restart of the timer:

Smart-sensor calibration or recalibration completes
Change is made to smart-sensor settings
Change is made to the timer setting

Supported on the following devices

Access Points (tri-radio) — AP4xx, AP8533
Access Points (dual-radio) — AP505i, AP510i/e, AP8432

Syntax

smart-sensor-status-timer <1-48>

Parameters

smart-sensor-status-timer <1-48>


smart-sensor-status-timer	Enables the timer for the sensor status check.
<1 – 48>	Sets the timer expiration (in hours). Once the timer expires, the sensor status check begins.

Examples

nx9500-6C8809(config-smart-rf-policy-test)#smart-sensor-status-timer 36

Related Commands


sh smart-sensor automatic-trigger-status on <Domain Name>	Displays the smart-sensor recalibration status for the specified RF domain.
show wireless radio on <Domain Name>	Displays the radio sensor status for the specified RF domain.
no (smart-rf-policy-config-mode-command)	Disables the smart-sensor-status-timer feature.